Honeywell RCA902N Uživatelský manuál stáhnout pdf (Strana 10)

Installation Instructions

69-2157EFS—05 8

NOTE: The detector can be configured to work with either a Chime or a Switching

ReceiverinDayorNightmode.Itcannotworkwithboth.

• Markthepositionofthefixingholesanddrilltwo6mmholes,theninsertthe

wallplugs(supplied).Iffixingtonon-solidorwoodsurfacethewallplugswillnot

be needed and only a small pilot hole will be required.

• Clipa9VPP3(6LR61)Alkalinebatterytotheconnectorandfitthebatteryinits

holder.

NOTE: When the battery is connected the LED behind the detector lens will continu-

ouslyflashorstayONwhilethedetectorgoesthroughits

warm up cycle. The unit will not operate normally until the

LED stops flashing.

• Fixtheunitinplaceonthewallandthenclosethe

cover ensuring it clicks fully closed.

• Adjustthesensorheadtopointinapproximatelythe

desired direction.

M27296

Fig. 4

69-2157EFS_C.indd 8 9/22/2008 11:54:00 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 79 80

Žádné komentáře

Honeywell RCA902N Uživatelský manuál Strana 10