Honeywell CT1503 Uživatelský manuál stáhnout pdf (Strana 9)

For CT1501 heating/cooling

□

Connect the wires to matching terminals on

the subbase.

A

POWER SOPPLV, PROVIDE DISCONNECT MEANS AND

■ OVERLOAD PROTECTION AS REQUinED.

NOTE: If there are four wires, connect wire

marked R to terminal RH arid add a jumper

wire to connect to RC. If RC is left uncon

nected, the air conditioner will not turn on. The

4-wire drawing on this page shows how to jumper

RC to RH Strip the insulation off the wire

where it connects to the terminals. Firmly tighten

screws.

4-WIRE SYSTEM

A POWER SUPPLY. PROVIDE DISCONNECT MEANS AND

OVERLOAD PROTECTION AS REQUIRED.

A \ INSTALL JUMPER BETWEEN RC AND RH.

If the labels do not agree with the terminal

designations on your new subbase:

• Refer to Table 2 on page 8,

• Determine correct hookup from the listed

control function and the equipment control

circuit.

69-0273—9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Komentáře k této Příručce

Žádné komentáře