Honeywell 191108AJ Uživatelský manuál stáhnout pdf (Strana 23)

23 69-0643—1

Thermometer Adjustment

The thermometer was accurately calibrated at

the factory and should only need adjustment if it

has been dropped or mishandled.

If the setpoint lever and the thermometer

reading do not agree, follow the procedure below.

Remove thermostat cover and open the flip-up

cover.

Set the thermostat cover on a table near a

thermometer of known accuracy.

Allow at least five minutes for cover thermom-

eter to sense area temperature; then compare

the readings. Be careful not to touch the ther-

mometer or breathe on it.

If the readings are the same, replace the

cover and put the system into operation.

If the readings are different, insert a small

screwdriver in the thermometer slot, shown in

Fig. 7, and turn it until both thermometers read

the same.

Fig. 7—Thermometer adjustment.

INSERT AND TURN

SCREWDRIVER

BACKSIDE OF

FLIP-UP COVER

THERMOMETER

SLOT

M1810

Replace thermostat cover and put the system

into operation.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Komentáře k této Příručce

Žádné komentáře